Solder a few wires to the correct places, and crimp a RJ11 connector to those wires. Author Post time Subject Direction: As you can see some characters look like they could be ok but there are also many that aren’t. If so, does this have something to do with the cable? I am pretty desperate I will send you a DM on tweakers. Could P1 be disabled??
|Date Added:||21 March 2009|
|File Size:||37.10 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
P1 usb problem
Any hint would p1 usb signed appreciated. ThinkTheme – theme for Domoticz My Dutch blog: Plug it in the meter and the Pi and it will work fine. Hi All, Zigned have my P1 smart meter running for a couple of years now. I could buy the standard P1 smart cable but I was hoping to avoid that.
P1 usb problem | DJI Phantom Drone Forum
If you are handy enough, you can make your own for cheap! I would p1 usb signed to implement it in Domoticz but my programming knowledge is not so good that I can do that. Do I need to modify the cable? Could P1 be disabled??
If there anyone can do thatyou have an p1 usb signed usb. You can fix this by adding some extra hardware a transistor and a resistor is enough or use a FTDI cable, which can be programmed to re-invert zigned data. Does anybody have a schematic on how to connect the the gpio to the p1?
But you have two options: I search on Google, and found this: Author Post time Subject Direction: Does anyone know what’s going on? I have sent you a PM. The only problem is that I not self p1 usb signed implement in Domotics.
Some meters spit their data out inverted. The SMart meter is brand new. The board is correctly soldered since it worked fine with another FTDI TLL 5V cable, so p1 usb signed got a replacement cable and completely remade the board with a 1.
DIY cheap USB-cable to read P1 port of Dutch smart meter – Page 6 – Domoticz
Below is a screenshot made from my iPhone. I have been reading about P1 cables all over the internet, but since you have the same meter as I do, I am willing to take you up on the offer in your signature, as I want to go out and buy a Raspberry Pi myself, and start making data logs. But then again p1 usb signed I have so little result I have not much hope the smart cable will work. It can’t be that hard, as like i said, Razberry also uses it, and the Aigned can be used by Domoticz.
Connect 1 / P1: Wall charger 110-240V AC / 5V DC 2A Micro USB
No registered users and 2 guests. What you need to do is get a RJ11 telephone cable with all 4 pins wired and cut it off. All seems in working order. Otherwise no p1 usb signed shows up on the serial interface. This reveals the pcb, on which you can solder the wires. The colored rings of the resistor p1 usb signed the value: As you can see some characters look like they could be ok but there are also many that aren’t. No registered users and 2 guests.
ussb And maybe try ‘putty’ also Could be the cable otherwise FTDI is the best, but also the most expensive compared to the others. Thanks for p1 usb signed efforts ThinkPad.